Diesel Power Type water well drilling machine
BZCY400WY truck mounted borehole drilling machine is a directly rotary drilling rig. This truck chassis is adopt the 6×4 special chassis of brand SINOTRUK, 11.00R20 steel off-road tire tread, with good off-road performance.
Speed of turntable（r/min）
Torque of turntable（KN.m）
Single rope lifting capacity of main windlass（KN）
The capacity of main windlass(KN)
Single rope lifting capacity of tool windlass(KN)
The rope capacity of tool windlass(m)
The lifting capacity of hook（KN）
Bearing capacity of mast (KN)
The height of mast (mm)
Bearing capacity (t)
Assistant pipe (mm)
Pump delivery (ml/r)
Rated speed (r/min)
Diameter of cylinder (mm)
Stroke of piston (mm)
Theory of flow (L / min)
Rated pressure (Mpa)
Pounding times (min-1)
Diameter of suction tube (mm)
Diameter of drain pipe (mm)
Input speed (r / min)
Input power (kw)
Overall dimensions (mm)
WP7.210E40 diesel engine
Rated power (kw)
The best working gear (or speed)
The highest speed（Km/h）
1. Truck type borehole drilling rig is convenient and flexible for moving. All devices are installed on the chassis, which is convenient for integration and movement. It adopts cross-country vehicle chassis to adapt to bad road condition.
2. Comprehensive design makes the machine work steady in extremely harsh climate.
3. For the high integration degree, preparation work before operation is quick and convenient.
4. It is applicable to the field of metallurgy, geology, petroleum, coal, water conservancy, forestry, troops, building materials and so on.
5. It is suitable for operating in clay layer, sand layer, gravel layer, gravel layer, bed rock, etc.
6. All rigs all adopt full hydraulic control, which is simple and convenient.
7. It is featured with low maintenance cost.
8. Our drilling equipments are accredited by the ISO9001:2008 certification, military enterprises certification and the implementation of national and military standards.
Measures for the use of the water well rig during the running-in period:
Reduce load, pay attention to inspection, and strengthen lubrication. As long as the maintenance and maintenance of the construction machinery running-in period are emphasized and implemented as required, it will reduce the occurrence of early failures, prolong the service life, improve the operation efficiency, and bring you more economic benefits.
How to improve the production efficiency of hydraulic water drilling rigs?
1. After the drill bit of the hydraulic water well drilling rig is drilled into the structure, the center drilling tool needs to be replaced in time. First, you need to clean the bottom of the hole and then blow off the residue at the bottom of the hole. After the drill bit stops rotating, the drill bit in the hydraulic water well drilling rig is drilled. It is most suitable when the lifting force is slowly increased and the lifting force is just enough to lift the drill bit.
2. The drilling process summarizes the drill bits of the hydraulic water well rig. It is also necessary to pay close attention to the subsequent working conditions of the casing, to know the specific conditions of the drilling in time, to clean the drilling holes in time, and to drill the drill bit on the water drilling rig. Strong lifting is prohibited during this process.
3. There will be more residue at the bottom of the hydraulic well rig. The eccentric drill bit will be stuck by the slag and affect its collection and production. At this point, it is necessary to deliver compressed air and clean the holes again. And let the down-the-hole hammer work for a short time, the water well rig model, and then re-do the center drill lifting work.